Handling and Transportation

For Transportation, mount product on an A-frame and secure accordingly. Protect edges and surfaces.
Card image cap
Ensure panels are carried vertically to prevent bending and cracking.
Card image cap
When storing, place panels flat, face up, on a smooth and dry surface. Elevate from ground to prevent moulding and other damages. Ensure all panels are stored dry and under cover. If the panels become wet or dirty, they must be dried and cleaned prior to installation.
Card image cap

Installation and Fixation
(Wet – Masonry installation)

Ensure wall surface is relatively flat
Card image cap
Pre-drill the required panel and cut out desired areas for fixtures
Card image cap
Prepare mortar glue following manufacturer instructions and spot apply as shown. Do not drill
Card image cap
Press panel firmly against the wall and secure with wooden beams. Allow up to 2 (two) hours for mortar glue to fully harden
Card image cap
Use tile spacers between the panels for desired jointing. We recommend 2-3mm.
Card image cap
Close joint and corner using preferred methods to protect the installation from humidity
Card image cap

Installation and Fixation
(Dry Frame walls)

Use gravanite steel profiles and fasten these to the floors, the walls, and ceiling with the appropriate screws.
Card image cap
Insert Insulator between the profiles to reduce noise pollution
Card image cap
Apply industrial tape on one side of the profile
Card image cap
Continue this process using thin set mortar between the boards to stabilize the connections
Card image cap
Place the final panel against the ceiling abutting the board profile
Card image cap
Open ended partition walls can be further stabilized then finished with our proposed board profile.
Card image cap

Jointing and Finishing

Corner trims are available in aluminium, stainless steel and offer long-lasting corner protection that also adds an aesthetically pleasing touch
Card image cap
Join trims are available in aluminium, stainless steel to create a luxurious look
Card image cap
Angle trims are available in aluminium, stainless steel and wood to create an aesthetically pleasing finish that adds long last protection for the edges in high-wear areas
Card image cap
Add grouting between the installed panels to protect them from humidity and make aesthetically pleasing
Card image cap
Metal or wooden skirtings are available to cover the bottom of the panels and create a clean room finish
Card image cap

Subscribe to Our Magazine

[sibwp_form id=1] [chatbot page_id=296991724138815]
preloader